wall plug
英 [ˈwɔːl plʌɡ]
美 [ˈwɔːl plʌɡ]
墙上插座
英英释义
noun
- receptacle providing a place in a wiring system where current can be taken to run electrical devices
双语例句
- Among 21 cases of benign cystic teratomas, the wall plug was demonstrated in 16 cases, solid mass in 3 cases, fat-fluid level in 2 cases.
21例良性者16例显示壁结节，3例为实质性肿块，2例见脂/液平面； - The pressure distributions on the wall surface of the plug nozzle models with two different truncated length were measured under different nozzle pressure ratios and the schlieren photos of typical cases were taken.
实验模型采用直排的点膨胀构型，实验测量了两种塞体长度的塞式喷管在不同压比条件下的表面压强分布，拍摄了典型工况下流场的纹影照片。 - The results show: at lower pressure ratio, heat transfer condition on the plug surface is the worst, peak values of pressure and temperature appear along the wall of plug nozzle, temperature and temperature gradient along the section of wall reach the highest.
计算结果表明塞式喷管发动机在较低压比的工况下工作时，塞锥受热状况较为恶劣，塞锥壁面出现压强和温度的峰值，该截面内部的温度和温度梯度达到最大。 - The wall plug is broken, isn't it?
墙上的插座坏了，不是吗？ - It is described in this paper how to get an adequate geometry of the piercing plug, including the taper length, nose thickness and the plug wall thickness, when conducting design of the said plug.
前言：介绍了在顶头设计中，如何正确选择穿孔锥长、鼻端厚及顶头壁厚的几何尺寸。 - Presented in the paper is a summary concerning the operational practice in manufacturing of extra-heavy wall seamless steel tubes with Φ 100mm plug pipe mill.
总结了在Φ100mm自动轧管机组上生产特厚壁无缝钢管的经验。 - Calculation of wall thickness of thick wall tube drawn without plug by using zhou-zhou formula
用双周数表计算空拔厚壁管的壁厚 - Non-uniform wall thickness of steel pipe rolled on plug mill
自动轧管机组轧制钢管壁厚不均问题的研究 - Linear deformation zone of generating wall can be obtained by means of non-linear cone angle plug combined with the barrel-shaped rolls, so the wall accuracy can be increased greatly.
采用带有非线性顶头锥角的顶头与桶形辊相配合可以获得线性的成壁变形区，从而大大提高壁厚精度。 - A wall plug or screw anchor is a type of fixing used in building.
壁塞是一种装修工具，用来安装在墙上，以安放螺丝。